Pushing Images

Sharing an image can be achieved by publishing it to a hosted repository. This is completely private and requires you to tag and push the image. When tagging an image, you can use the image identifier (imageId). It is listed when showing the list of all images with docker images. Syntax and an example (using imageId) for creating a tag are:

docker tag <imageId or imageName> <nexus-hostname>:<repository-port>/<image>:<tag>
docker tag af340544ed62 nexus.example.com:18444/hello-world:mytag

Once the tag, which can be equivalent to a version, is created successfully, you can confirm its creation with docker images and issue the push with the syntax:

docker push <nexus-hostname>:<repository-port>/<image>:<tag>

Note that the port needs to be the repository connector port configured for the hosted repository to which you want to push to. You can not push to a repository group or a proxy repository.

A sample output could look like this:

$ docker push nexus.example.com:18444/hello-world:labeltest
The push refers to a repository [nexus.example.com:18444/hello-world] (len: 1)
Sending image list
Pushing repository nexus.example.com:18444/hello-world (1 tags)
535020c3e8ad: Image successfully pushed
af340544ed62: Image successfully pushed
Pushing tag for rev [af340544ed62] on

Now, this updated image is available in the repository manager and can be pulled by anyone with access to the repository, or the repository group, containing the image. Pulling the image from the repository group exposed at port 18443 can be done with:

docker pull nexus.example.com:18443/hello-world:labeltest

Prior to push, and depending on your configuration, repository manager login credentials may be required before a push or pull can occur.

Searching, Browsing, Pushing and Pulling are all showcased in this video.

Pushing large images can result in failures due to network interruptions and other issues. These partial uploads result in temporary storage for these transfers in the repository manager filling up. The task Purge incomplete docker uploads can be configured to delete these files. If you also tend to upload images to the same tag repeatedly, this can leave a lot of dangling images around, consuming a lot of space. The task Purge unused docker manifests and images can be configured to remove these files. Further information about these tasks can be found in Configuring and Executing Tasks.